EQUILIBRIUM RELATIVE HUMIDITY PROBE MODE
Use Shortcut Menu to select from
Recently Used scales.
Use Full Menu to select Pin Scale
options (Wood Standard, Wood Species,
WME, Drywall, Pin Temperature)
Attach the pin-probe (if purchased) into
Bayonet connection at top of the instrument.
(Line up arrow on front and twist.)
The built-in Relative Humidity Sensor provides
Temperature, Relative Humidity, DewPoint and
grains per pound readings.
Last scale used is memorized on power off and
automatically restored on next power up.
Hold/freeze: Press once, “II” will appear on
the screen. Press again to release hold.
(If powered down while on Hold, will retain infor-
mation until powered up and hold pressed again
to release)
CONCRETE %MC scale: Quantitative %MC
Moisture Content by mass/weight readings for
Concrete slabs and sand/cement screeds using
Gravimetric testing as a baseline.
CM CONCRETE scale: Equivalent reading to
Carbide Method (CM) test for Concrete slabs and
Sand/Cement screeds.
CM ANHYDRITE: Equivalent reading to Carbide
Method (CM) test for Anhydrite, Hemi-hydrate,
Gypsum and Calcium Sulphate Screeds.
GYPSUM REF 0-12: Reference readings repli-
cating measurements using concrete scale on
concrete & sand/cement floors/screeds, for use
on Gypsum floors/screeds.
REFERENCE 0-99 scale: Comparative/qualita-
tive scale to identify areas with moisture; where
direct contact to bare concrete is not possible
due to thin coating or covering; for non-concrete/
screed materials such as ceramic tiles or stone.
PIN-PROBE WOOD/WME MODE
When pins are inserted into wood, measure-
ments of 5% to approx. 30% are displayed.
WME scale is a Wood Moisture Equivalent
scale for comparative pin readings in many
building materials.
DRYWALL scale is a comparative scale for
use in drywall.
Attach the RH cable and probe (if purchased)
into the Bayonet connection at the top of the
instrument. (Line up arrow on front and twist.)
To Next Page
Loading...
Need help?
General
