EasyManua.ls Logo

Trane 4TTR3060N User Manual

Trane 4TTR3060N
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
18-AC79D1-10D-EN
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
IMPORTANTThis Document is customer property and is to remain with this unit. Please return to service informa-
tion pack upon completion of work.
Condensing Units
These instructions do not cover all variations in systems or provide for every possible contingency to be met in connection with
the installation. Should further information be desired or should particular problems arise which are not covered sufficiently for the
purchaser’s purposes, the matter should be referred to your installing dealer or local distributor.
Note: The manufacturer recommends installing only approved matched indoor and outdoor systems. Some of the benefits of
installing approved matched indoor and outdoor split systems are maximum efficiency, optimum performance and the best overall
system reliability.
4TTR3
Table of Contents
Section 1. Safety ..................................................................................... 2
Section 2. Unit Location Considerations ............................................. 3
Section 3. Unit Preparation .................................................................... 5
Section 4. Setting the Unit ..................................................................... 5
Section 5. Refrigerant Line Considerations ......................................... 6
Section 6. Refrigerant Line Routing ..................................................... 8
Section 7. Refrigerant Line Brazing ...................................................... 9
Section 8. Refrigerant Line Leak Check ............................................. 11
Section 9. Evacuation .......................................................................... 12
Section 10. Service Valves .................................................................. 12
Section 11. Electrical - Low Voltage ................................................... 13
Section 12. Electrical - High Voltage .................................................. 15
Section 13. Start Up .............................................................................. 16
Section 14. System Charge Adjustment ............................................. 17
Section 15. Checkout Procedures ...................................................... 23
Section 16. Refrigerant Circuits .......................................................... 24
Section 17. Wiring Diagrams ............................................................... 26
Section 18. Pressure Curves ............................................................... 34
Installation and Operation Manual
Question and Answer IconNeed help?

Do you have a question about the Trane 4TTR3060N and is the answer not in the manual?

Trane 4TTR3060N Specifications

General IconGeneral
TypeHeat Pump
Cooling Capacity60, 000 BTU
Heating Capacity60, 000 BTU
HSPF Rating9.0
RefrigerantR-410A
Voltage208/230V
Phase1
SEER Rating16.0

Summary

Safety

Refrigerant Line Considerations

Refrigerant Line & Service Valve Sizes

Details line sizes and service valve connection sizes for various models.

Refrigerant Line Brazing

Braze Refrigerant Lines

Step-by-step instructions for preparing and brazing refrigerant lines.

Refrigerant Line Leak Check

Check For Leaks

Procedure for pressurizing lines with nitrogen and checking for leaks with soapy solution.

Evacuation

Evacuate Refrigerant Lines & Indoor Coil

Instructions for evacuating the system to a specific micron level.

Service Valves

Electrical - High Voltage

High Voltage Power Supply

Details requirements for high voltage power supply and compliance with codes.

Start Up

System Start Up Procedure

Step-by-step guide to safely start up the system after installation.

System Charge Adjustment

Subcooling Charging (Above 55° F Outdoor)

Procedure for adjusting system charge using subcooling above 55°F outdoor temperature.

Subcooling Charging (Below 55° F Outdoor)

Recommended charging method for outdoor temps below 55°F is weighing the charge.

Checkout Procedures

Operational and Checkout Procedures

Final unit operational checks and procedures to ensure proper performance.

Refrigerant Circuits

Wiring Diagrams

Wiring Diagrams (Specific Models)

Wiring diagram for multiple model series, including a legend.

Wiring Diagram (024N Models)

Wiring diagram for the 024N model, detailing connections and components.

Wiring Diagram Details (024N Models)

Further details and notes for the 024N model wiring diagram.

Pressure Curves

Related product manuals