51
• Don't clean it with hot water of over 50°C to avoid fading or distortion.
• Don't dry it on the re, or the cleaner might cause re.
1.Install the air cleaner: The method is contrary to the method ofremoving the dust screen.
2.Install the Inlet guide plate: As shown below, the rack on the return air guide plate is inserted into the gear box.
• Cleaning
Clean the air cleaner with the dust collector or water to remove dusts.
For too much dust, use the fan or directly spray the special cookware detergent on the air inlet grid, and then clean
it with water after 10 minutes.
(A) remove dust with dust collector.
(B) for too much dust, use soft-hair brush and mild detergent to clean.
(C) throw o water and then dry it at cool places.
Attention
Opposite fastener
Fastener
Rack
Clean the air cleaner
Install the air cleaner & Inlet guide plate
The hole of gear wheel box Rack
To Next Page
Loading...
