Trane A4AH4E36A1C30A - User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
July 2022
1188--GGFF1166DD11--11AA--EENN
Convertible Air Handlers
1–1/2 — 5 Ton
A4AH4E24A1B60A
A4AH4E30A1B30A
A4AH4E36A1C30A
A4AH4E42B1C30A
A4AH4E48B1C30A
A4AH4E60B1C30A
The A4AH4 series air handler is designed for installation in a closet,
utility room, alcove, basement, crawlspace or attic. These versatile
units are applicable to air conditioning and heat pump
applications. Several models are available to meet the specific
requirements of the outdoor equipment. Field installed electric
resistance heaters are available.
Installer’s Guide

Summary

Safety Section

Electrical and Refrigerant Hazards

Details electrical safety, warnings about live components, and grounding necessities.

Physical and Operational Safety

Additional Safety Precautions

Child Safety and Chemical Warnings

Installation Instructions

Unpacking, Location, and Ductwork

Guides on initial setup, placement, and duct installation requirements.

Condensate Drain and Piping

Operational Checks and Maintenance

Details final system checks, operational procedures, and ongoing maintenance.

Installation Instructions

Blower, Wiring, and Thermostat

Sequence of Operation

Electrical and Wiring Information

Field Wiring Diagrams

Electrical Schematic and Data

Minimum Airflow CFM Requirements

Outline Drawing and Dimensions

Unit Outline and Product Dimensions

Coil Conversion Instructions

Downflow Configuration Conversion

Step-by-step guide for converting the air handler to a downflow configuration.

Horizontal Right Configuration Conversion

Step-by-step guide for converting the air handler to a horizontal right configuration.

Checkout Procedures

Final Installation Checkout Checklist

A checklist to confirm all installation requirements and system functions are met.

Trane A4AH4E36A1C30A Specifications

General

Cooling Capacity	36000 BTU
SEER	Up to 16
HSPF	Up to 9.0
Stages	Single
Voltage	208/230 V
Nominal Cooling Capacity	3 Tons
Phase	1
Motor Type	ECM
Airflow Range	1200-1200 CFM
Filter Type	Standard