Service Model Numbers –Solid State Motor Starter
An example of a typical Solid State ” IT ” starter model number is:
CVSR0035FAA01EA0E1
Model Number Digit Identification - Model number digits are selected and assigned
in accordance with the following definitions using the model number example shown
above.
C = (1st digit)
V = 2nd digit)
S = (3rd digit)
R = (4th digit) Development Sequence
R = Cutler Hammer Solid State ” IT ” starter for gear drive centrifugal chillers with
AdaptiView controls
0035 = (5th, 6th, 7th, and 8th digit) Starter Size
Use Rated Load Amps (RLA) value
F = (9th digit) Unit Voltage
D = 380V-60Hz-3Ph
F = 460V-60Hz-3Ph
H = 575V-60Hz-3Ph
R = 380V-50Hz-3Ph
T = 400V-50Hz-3Ph
U = 415V-50Hz-3Ph
S = Special
A = (10th digit) Design Sequence
A = Original Design
A = (11th digit) Starter Type
B = Unit Mounted
M = Remote Floor Mounted
N = Remote Wall Mounted
S = Special
0 = (12th digit) Connection Type
0 = Terminal Block
1 = Disconnect Switch - Non-Fused
2 = Circuit Breaker
3 = Circuit Breaker Current Limiting
4 = Circuit Breaker High Interrupt Cap
5 = Circuit Breaker Higher Interrupt Cap
S = Special
1 = (13th digit) Agency Listing
1 = UL & cUL Listed (Standard on all units)
2 = CE
E = (14th Digit) Power Factor Correction Capacitor
0 = None
D = 25 KVAR
E = 30 KVAR
F = 35 KVAR
G = 40 KVAR
H = 45 KVAR
J = 50 KVAR
K = 60 KVAR
L = 70 KVAR
M = 75 KVAR
CVGF-SVX03B-EN
15
General Information
To Next Page
Loading...
