6
MUA-SVX006B-EN
Receiving Instructions
Make-up Air Units with multiple furnaces are shipped in sections. Each section has a label with
Order No., Model No., Unit No., and Part No. marked on it. Make certain that the order, model,
and part numbers agree on each section to be connected together. Inspect shipment immediately
when received to determine if any damage has occurred to the crate during shipment. After the
unit has been uncrated, check for any visible damage to the unit. Check motor position and turn
blower wheel to determine if damage has occurred to these critical parts. If any damage is found,
the consignee should sign the bill of lading indicating such damage and immediately file claim
for damage with transportation company.
Pre-Installation Instructions
Installer Please Note: This equipment has been test fired and inspected. It has been shipped free
from defects from our factory. However, during shipment and installation, problems such as
loose wires, leaks or loose fasteners may occur. It is the installer's responsibility to inspect and
correct any problems that may be found. When the unit is received and uncrated, check the
external data plate and all labels on the unit for type of gas, electrical, and operational
specifications to confirm that these agree with those at point of installation. The unit is equipped
with a Duct Furnace, also check the data plate and all labels located on each furnace. Every Make-
Up Air unit will include an informational packet which will include the following: This make-up air
manual, duct furnace and evaporative cooler/cooling coil manuals (if applicable to the unit
order), wiring diagram(s), and special controls/data sheets.
NNoottee:: It is the owner's responsibility to provide any scaffolding or other apparatus required to
perform emergency service or annual/periodic maintenance to this equipment.
To Next Page
Loading...
Need help?
General