Instructions:
- Remove keypad panel from the TR200
- Remove the frame located beneath and discard
- Push the option into place. Two positions are possible, with cable terminal facing either up or down
- Push the serial communication bus option adaptor frame for the TR200 into place
- Replace the keypad and attach cable
- On A1 and A2 enclosures with cable terminal facing up: Fasten the cable onto the de-coupling plate (the
TR200 top surface has pre-drilled threaded holes for attaching the de-coupling plate to the unit).
130BT341.10
How to install
TR200 LonWorks 4-7
To Next Page
Loading...