Trane Odyssey TWE3004*B User Manual

SSAAFFEETTYY WWAARRNNIINNGG
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning
equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person
could result in death or serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that
are attached to the equipment.
March 2020
SSSSAA--SSVVXX0066HH--EENN
Installation, Operation, and Maintenance
Split System Air Conditioners
Odyssey™ with Symbio™
Controls
Air Handler — 5 to 25 Tons
MMooddeell ((6600 HHzz))
TWE0604*A/B
TWE0724*B
TWE0904*A/B
TWE1204*A/B
TWE1504*B
TWE1804*B
TWE2404*B
TWE3004*B
MMooddeell ((5500 HHzz))
TWE0514DA
TWE0724DB
TWE0764DA/B
TWE1014DA/B
TWE1264DB
TWE1564DB
TWE2014DB
TWE2514DB

Trane Odyssey TWE3004*B Specifications

General

Model Number	TWE3004*B
Category	Air Conditioner
Cooling Capacity	30000 BTU/h
Voltage	208/230V
Phase	1
Refrigerant	R-410A

Summary

Introduction and Safety

Safety Advisories and Precautions

Defines safety advisory types (Warning, Caution, Notice) and mandates PPE, safe wiring, and grounding.

EHS Policies and Refrigerant Hazards

Covers EHS policies, high-pressure refrigerant warnings, and explosion hazards.

Model Number Description

Pre-Installation Procedures

Unit Inspection and Testing

Inspecting for damage, leak testing, and checking components before installation.

Field Conversion and Piping Preparation

Steps for 460V conversion, refrigerant piping prep, and installation recommendations.

Installation

Refrigerant and Condensate Piping

Attaching expansion valve bulbs and condensate piping details.

Electrical Wiring and Power Supply

Safety, field wiring, grounding, and unit power supply requirements.

Control System Wiring

Symbio controls wiring, thermostat, and zone sensor connections.

Installation Checklist

Final verification checklist before system startup.

Field Wiring

Condenser to Air Handler Pairings

Checkout Procedure

Final steps and checklist completion before system startup.

Startup Procedures

Symbio Controller Configuration

Condenser and Air Handler Configuration

Field Installed Electric Heat Kit Configuration

Electric Heat as Secondary Heat Configuration

Maintenance Procedures

Fan Belt Adjustment and Safety

Wiring Diagram Matrix and Device Location