To Next PageTo Next Page
Need help?Do you have a question about the Trane Precedent WSC060ED and is the answer not in the manual?
General| Model Number | WSC060ED |
|---|---|
| Category | Air Conditioner |
| Cooling Capacity | 5 Tons |
| Refrigerant Type | R-410A |
| Voltage | 208/230V |
| Phase | 3 |
| Compressor Type | Scroll |
Decoding digits for unit type and efficiency ratings.
Interpreting capacity MBH and voltage selection digits.
Understanding digits for controls, options, and communication.
Explaining digits for monitoring and hardware upgrades.
Notes on unit availability, dampers, and motor types.
Details on economizer configurations and specific options.
Notes on smoke detectors and accessory compatibility.
Details on unit and compressor nameplates.
Description of unit, ECA, and ReliaTel modules.
Overview of sensors and their functions.
Input functions for fan failure and clogged filters.
Overflow switches, compressor disable, and pressure controls.
ReliaTel options and Zone Sensor Module details.
Details on programmable and various remote sensors.
High temp sensor, frost control, and phase monitoring.
Visuals showing side-by-side and end-to-end clearances.
Explanations for specific unit configurations and dimensions.
Steps for inspecting and storing the unit.
Importance and impact of proper unit clearances.
Requirements for unit support and air duct connections.
Diagrams for horizontal supply and return airflow.
Diagrams for downflow supply and return airflow.
Installation of roof curbs and unit rigging procedures.
Safe methods for rigging and lifting the unit.
Key steps for successful commercial unit installation.
Setup for factory economizers and condensate drain.
Procedures for converting to horizontal discharge.
Requirements for AC and DC low voltage wiring.
Instructions for configuring condensate drainage and traps.
Procedures for drain pan removal and filter installation.
Guidelines for field-installed power and control wiring.
Transformer details and 24 VAC control wiring.
Guidelines for DC analog signal wiring.
Wiring methods for averaging multiple remote sensors.
Procedures for checking voltage imbalance and electrical phasing.
Importance and operation of crankcase heaters.
Methods for testing unit components during start-up.
Self-diagnostics and test procedures for the ReliaTel system.
Methods for measuring and verifying unit airflow.
Procedures for adjusting belt drive fan speed.
Procedures for starting economizer and compressors.
Steps for heating start-up and final system configuration.
Methods for measuring and adjusting belt tension.
