EasyManua.ls Logo

Trane Precedent WSJ180 - User Manual

Trane Precedent WSJ180
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment
can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment by an unqualified person could result in death or
serious injury. When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are attached to the equipment.
December 2022
PKGP-SVX010A-EN
Installation, Operation, and Maintenance
Packaged Rooftop Air
Conditioners
Precedent™ Heat Pump
Standard Efficiency
12.5 to 25 Tons 60 Hz
Model Numbers: WSJ150A - WSJ300A
Question and Answer IconNeed help?

Do you have a question about the Trane Precedent WSJ180 and is the answer not in the manual?

Trane Precedent WSJ180 Specifications

General IconGeneral
ModelWSJ180
CategoryAir Conditioner
Energy Efficiency Ratio (EER)10.7
RefrigerantR-410A
Voltage208-230V
Phase3
Compressor TypeScroll
Cooling Capacity180, 000 BTU
Operating Range125°F

Summary

Introduction

Warnings, Cautions, and Notices

Defines safety advisories: WARNING, CAUTION, and NOTICE.

Proper Field Wiring and Grounding

Emphasizes requirements for safe and proper field wiring and grounding.

Personal Protective Equipment (PPE)

Details essential PPE for technician safety during installation and servicing.

EHS Policies

Mandates adherence to company and local Environmental, Health, and Safety policies.

General Information

Unit Inspection

Procedures for inspecting units upon receipt for shipping damage and completeness.

Zone Sensors and Thermostats

Describes various zone sensors and thermostats for temperature control and operation.

Phase Monitor

Explains the phase monitor's function in detecting voltage imbalance and phase sequence.

Pre-Installation

Hazardous Voltage Safety

Critical safety warning about disconnecting power before servicing.

Dimensional Data

Lifting and Rigging

Instructions and warnings for safely lifting and rigging the unit.

Installation

Combustible Materials

Warnings about maintaining clearances from combustible materials to prevent fire.

Rigging

Detailed instructions and warnings for rigging the unit during installation.

Main Electrical Power Requirements

Critical information on power supply compatibility, wiring, and grounding.

Field Installed Power Wiring

Requirements for field-installed power wiring, including grounding and conductor types.

Main Unit Power

Safety and wiring requirements for connecting the main unit power supply.

Field-Installed Control Wiring

Safety and wiring guidelines for field-installed control wiring.

Pre-Start

Hazardous Voltage and Capacitors

Warning regarding high voltage and capacitors before servicing.

Rotating Components Safety

Safety precautions when working with exposed rotating components.

Voltage Imbalance

Requirements for three-phase power supply voltage balance for motor longevity.

Electrical Phasing

Procedures for verifying proper electrical phasing for three-phase motors.

Unit Start-Up

Compressor Start-Up

Procedures and safety checks for starting compressor circuits.

Final System Setup

Final checks and programming before leaving the unit after startup.

Maintenance

Hazardous Service Procedures

General safety precautions for performing maintenance tasks.

Coil Cleaning

Procedures and safety for cleaning evaporator and condenser coils.

Coil Cleaning Procedure

Detailed steps for safely cleaning the unit's coils.

Troubleshooting

Wiring Diagrams

Piping Diagrams

Related product manuals