PTAC-SVX004A-EN
29
connection board and then remove the middle
connection board.
19. Remove the screw holding the cable cross and then
remove the cable cross.
WWAARRNNIINNGG
RReeccoovveerr RReeffrriiggeerraanntt!!
PPlleeaassee bbee ssuurree ttoo rreeccoovveerr rreeffrriiggeerraanntt ppeerr ssttaannddaarrdd
pprroocceedduurreess aanndd gguuiiddeelliinneess bbeeffoorree pprroocceeeeddiinngg wwiitthh
aaddddiittiioonnaall sstteeppss bbeellooww..
20. Unsolder the spot weld between the 4-way valve
and the compressor, condenser, and the
evaporator. Remove the 4-way valve.
21. Remove three (3) nuts holding the compressor and
then remove the compressor.
22. Unsolder the spot weld between the capillary sub-
assembly and condenser Remove the capillary.
23. Remove six (6) screws holding the guide loop sub-
assembly and then pull upwards to remove the
guide loop sub-assembly.
24. Remove the nuts holding the axial flow blade and
the pull outwards to remove the axial flow blade.
25. Remove four (4) screws holding the motor and then
remove the motor.
DDiissaasssseemmbblliinngg tthhee UUnniitt
To Next Page
Loading...
