11 48663967 Rev 1
Contents
2. Operation
2.1. Remote Operation
t Make sure power is ON
t Select the room which needs to be controlled.
t Refer section 2.4.2 for dierent functions of remote.
2.2. Manual and Auto Restart Operation
Manual operation can be used temporarily in case remote controller is not available.
t Lift Front panel up to an angle, it stays attached with a clicking sound (Refer Figure - 2).
Do not lift front panel at an angle above 60 degrees. Do not apply too much force.
Figure - 2
t When you press manual control button (Figure - 3), the unit is switched on at the following default
conditions
MODE: COOL FAN SPEED: MEDIUM SWING: AUTO SET TEMP: 24 °C
t Lower the front panel to its initial position.
Manual control button
Figure - 3
t Use object not more than 5mm in diameter to press manual control button.
t To restore remote control operation, use remote control directly.
t The Display LED status will not change when unit is operated through manual control button.
Auto Restart Function
t Power cut during operation will stop the unit completely.
t Unit starts automatically with all previous settings saved in memory function when the power is restored.
To Next Page
Loading...
