16 48663967 Rev 1
Contents
In high humidity conditions, user can select dry mode.
2.4.2.4. Fan Mode
1. Press MODE to select fan mode, see ‘FAN’ shown on display.
Set point temperature cannot be adjustable.
Fan speed can be adjustable.
2.4.2.5. Sleep Mode
1. Press to activate sleep mode operation.
The ‘set’ temperature will automatically increase by 1°C for each
hour for four hours.
After 4 hours unit will stay at latest temperature. E.g., if the
set temperature is 24°C and sleep mode is started. After rst hour
set temperature will increase to 25°C and at the end of fourth hour
set temperature will be at 28°C. The unit will stay at 28°C.
Press again to disable sleep mode.
Set point temperature and fan speed can be adjustable.
2.4.2.6. Turbo Mode
1. Press to activate turbo mode. See ‘TURBO’ on remote display.
Enables instant cooling by automatically adjusting fan speed to
turbo level.
Fan speed cannot be changed while unit is in turbo mode.
The display will not show the fan speed bar (Refer Figure - 13).
User can set this mode for fast cooling.
Press again to disable turbo mode.
2.4.2.7. Fan speed
1. Press fan speed to change fan speed.
Fan speed can be changed as below
Low
Medium
High
Auto
Fan speed is adjusted automatically according to set point and
room temperature when FAN speed is set to AUTO mode.
2.4.2.8. Night latch Mode (Only for units with “TRANE Lock”)
LOCK
Night latch Mode
Ac!va!on/Deac!va!on
AC Remote
e
Display
Figure - 15
Press Twice
Away
Home
Passage
Night Latch
1
e
Display
Figure - 11
1
Display
Figure - 12
e
1
Display
Figure - 13
e
Display
Figure - 14
e
1
To Next Page
Loading...
