31
Fabricating Refrigeration Hoses
Cut the Hose
1. Cut the hose to proper length with an appropriate cutting tool.
Hand-held hose cutter (204-677) has been specially designed for
cutting all non-wire reinforced hose, such as TK 2000 Multi-refrigerant
hose. Be sure the cut is made square to the hose length.
Slip on Two Clamps
2. Install two proper- size clips onto the cut end of the hose. Orientation of
the clips does not affect the performance of the connection. However
for ease of assembly, both clips should have the same orientation.
CAUTION: Failure to slide the clips over the hose at this time will
require the clips to be stretched over the hose or fitting later.
This may permanently damage the clip
To Next Page
Loading...
