35
Fabricating Refrigeration Hoses
NOTE: Thermo King recommends adherence to all guidelines, including
EPA guidelines concerning the service of refrigerant systems.
Minimum Bend Radii CAUTION: TK 2000 Speedy Clip System components should not
be reused. Failure to follow these instructions and/or the use of
TK 2000 Speedy Clip System hose with fittings supplied by other
manufactures could result in sudden or unintended escape of
refrigerant gases. Personal injury and/or violations of EPA
regulations may occur as a consequence.
Improperly Installed Clip Properly Installed Clip
All hoses must be routed as to maintain the
minimum bend radii given in the table below.
Hose
Size
Minimum
Bend
Radius
#6 2.00 in.
#8 2.50 in.
#10 3.00 in.
#12 4.00 in.
#16 7.00 in.
To Next Page
Loading...
