Installing your thermostat
3. Setting the Sleeping
Press and Hold M to set the sleeping. will flash.
Press to confirm, to cancel.
6. Setting functions and options
During power off, press and hold at the same
time for 5 sec. to system functions. Then press M
to change the di
f
ferent items.
All the settings will
confirm automatically
This product is suitable for standard 86mm wall
box or european 60mm round box.
1. Connect the wire of power and other equipment into
the terminals.
2. Fix the wall plate into the wall box by a screwdriver.
3. Connect the LCD board into the wall plate.
4. Finished.
(Fig 1)
(Fig 2)
(Fig 4)
(Fig 3)
WARNING: Please arrange the professional technician
to install this product according to installation drawing and
instruction.
RISK OF ELECTRICAL SHOCK. Disconnect power supply
before making electrical connection. Contact with components
carrying hazardous voltage can cause electrical shock and may
result in severe personal injury or death.instruction.
4.Selecting manual and programmable
Press and hold , will flash. Press again, M
Press to select manual and press
to select weekly programmable.
5. Adjusting the weekly programmable
Then press M to change the different items.
The order is Minute adjusting→ Hour adjusting
→ Week adjusting→ Minute timing-on → Hour
timing-on→ Minute timing-off→ Hour timing-off→
Temperature adjusting (
“12345”,”6”,”7”, is “5+1+1” programmable mode,
every mode has two times zones and a time
temperature setting)
Week
First Period Second Period
Turn-on
me
Turn-off
me
Set
temp.
Turn-on
me
Turn-off
me
Set
temp.
Mon. to Fri. 1 2 3 4 5 6
Sat. 7 8 9 10 11 12
Sun. 13 14 15 16 17 18
M
will flash.
Press to set minutes of the time;
Press to set hours of the time;
Press to set week of the time;
M
M
M
Press into the adjustment of programmable.M
After the above steps, press into programmable.M
Press or to set the relative values.
Wiring your thermostat
M
Press or to set the
relative values.
Dimension of your thermostat
86.0
86.0
65.9
48.6 13.2
13.2 29.6
49.6
50.0
50.0
Unit: mm
No Func on Se ng & Op ons Default
1
Temp.
Calibra
on
-9℃ to 9℃ 0℃
2 Fan Control
0:When room temp. reaches
the setpoint, the fan will turn
off.
1:When room temp. reaches
the setpoint, the fan will turn
To Previous Page
Loading...
