Trane TR1 Series VFD - Wiring Instructions (Continued); Wiring to Drive from Analog Output 42; Wiring to Drive from Analog Output 45

10
Output 45
04 05 12 13 39 42 45 50 53 54 55 60
16 17 18 19 20 27 29 32 33
61 68 69
110
111
112
113
114
VLT 5000
®
Relay Option
Internal
Relay
Contacts
Output 42
04 05 12 13 39 42 45 50 53 54 55 60
16 17 18 19 20 27 29 32 33
61 68 69
110
111
112
113
114
VLT 5000
®
Relay Option
Internal
Relay
Contacts
Wiring (continued)
To Drive from Analog Output 42:
Wire as shown in figure 2 below. Program the relay using parameter 319.
To Drive from Analog Output 45:
Wire as shown in figure 3 below. Program the relay using parameter 321.
Tighten terminals on drive terminal strip to 5 in-lbs (0.6 N-m).
Tighten terminals on option card to 3.5 in-lbs (0.4 N-m).
TR1 VFD
TR1 VFD