Trane Voyager THD240G User Manual

SAFETY WARNING
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-
conditioning equipment can be hazardous and requires specific knowledge and training. Improperly installed, adjusted or altered equipment
by an unqualified person could result in death or serious injury. When working on the equipment, observe all precautions in the literature and
on the tags, stickers, and labels that are attached to the equipment.
Packaged Rooftop Air Conditioners
Voyager™
– Electric/Electric
12.5 to 25 Tons, 60/50Hz
February 2017
RT-SVX25M-EN
Installation, Operation,
and Maintenance
Model Number:
TS*150–301
TH*150-300

Trane Voyager THD240G Specifications

General

Model	THD240G
Category	Air Conditioner
Cooling Capacity	20 Tons
Refrigerant	R-410A
Compressor Type	Scroll
Voltage	460V
Phase	3
Airflow	8000 CFM
EER	11.2

Summary

Safety and Operational Precautions

Electrical and PPE Safety Requirements

Stresses qualified personnel for wiring and mandatory PPE for hazard prevention.

Model Number Interpretation

General Information

System Input Devices and Protection

Unit Weights

Weight Data and Rigging Procedures

Lists unit weights and details safe rigging methods, emphasizing warnings.

Installation Procedures

Foundation, Ductwork, and General Requirements

Control Wiring and Safety Checks

Instructions for power wiring, control wiring, and critical electrical safety checks.

Factory-Mounted Options Installation

Instructions for installing circuit breakers, disconnects, convenience outlets, and smoke detectors.

Pre-Start and Start-Up Procedures

Guides for unit test modes, air flow verification, economizer, compressor, and heating start-up.

Maintenance Procedures Overview

Troubleshooting and Diagnostics

ReliaTel Control and System Status

Diagnosing ReliaTel issues and interpreting system status via LEDs.

Failure Troubleshooting and Lockout Resets

Addressing specific failures and methods for resetting lockouts.

Sensor and Component Testing

Programmable Sensors and Economizer Troubleshooting

Wiring Diagrams