EasyManua.ls Logo

Transas Class B - AIS Alarm Messages (NMEA 0183 ALR, Text); ALR Message Format

Transas Class B
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LD2103 V3.0 Page 19 of 33
SRT Marine
Instruction Manual
SRT-MTB
©
Class B Marine AIS
•
x3 = Channel A bandwidth
•
x4x4x4x4 = Channel B
•
x5 = Channel B bandwidth
•
x6 = Tx/Rx mode control
•
x7 = Power level control
•
a3 = Information source
•
x8 = In-Use Flag
•
hhmmss.ss = Time of "in-use" change
Channel management information source messages (NMEA 0183 ACS)
This sentence is used in conjunction with the ACA sentence and identifies the originator of an ACA message.
ACS Message Format
$--ACS,x,xxxxxxxxx, hhmmss.ss,xx,xx,xxxx*hh <CR><LF>
•
x = Sequence Number , 0 to 9
•
xxxxxxxxx =MMSI of originator
•
hhmmss.ss = UTC of receipt of channel management information
•
xx = UTC Day, 01 -31
•
xx = UTC Month, 01 -12
•
xxxx = UTC Year
AIS Alarm Messages (NMEA 0183 ALR, Text)
ALR message format
$--ALR,hhmmss.ss,xxx,A,A,c--c*hh<CR><LF>
Where
•
hhmmss.ss = Time of alarm (UTC)
•
xxx = Unique alarm number
•
A = Alarm condition
•
A = Alarm acknowledge state
•
c--c = alarm description, text
Alarms descriptions presented are:
•
AIS: TX malfunction
•
AIS: Antenna VSWR exceeds limit
•
AIS: Rx channel 1 malfunction
•
AIS: Rx channel 2 malfunction
•
AIS: general failure
•
AIS: no sensor position in use
•
AIS: no valid SOG information
•
AIS: no valid COG information
Transas Class B - AIS Alarm Messages (NMEA 0183 ALR, Text); ALR Message Format