VIDEO STAMP
Video Stamp: Display the time of the video being recorded.
Date / Time: Set the date and time format. You can select 24-hour or 12-hour time format.
Available options: YYYY/MM/DD / MM/DD/YYYY / DD/MM/YYYY, 24HR / AM/PM
DEVICE
G-Sensor: Adjust the sensitivity of the G-Sensor.
Available options: Disable / Low (default) / Medium / High
Delay Power Off: Schedule the DrivePro to shut down at a certain time.
Available options: Disable / 10 secs (default) / 30 secs
Wi-Fi: You may change the default SSID for the DrivePro’s wireless network.
Note: If you change the SSID, it will be renewed when you reconnect to Wi-Fi.
SYSTEM
Time Synchronized: Synchronize the DrivePro’s system time to that of your smart
device’s.
Format SD Card: Tap to format your microSD card.
Version: Tap to upgrade the firmware to the latest version.
WARNING: NEVER remove the power cable or the microSD memory card while the
firmware is being upgraded.
1. The DrivePro™ will shut down and the red LED light will flash while the firmware is
being upgraded. After the upgrade is complete, the DrivePro™ will restart
automatically.
2. If the DrivePro™ cannot be turned on due to firmware upgrade failure, please
contact Transcend customer service for technical support.
To Next Page
Loading...
