Transcend DrivePro 550B - Page 17

16
6-1 Menu Options
Camera
Icon
Feature
Function/Option
Resolution
Set the resolution/quality for video recording (front lens+rear lens).
1080P 60fps+1080P 30fps / 1080P 30fps+1080P 30 fps(default) /
720P 30fps+720P 30fps
Exposure Value
Adjust exposure composition value to lighten or darken the
preview screen.
+2.0 / +1.5 / +1.0 / +0.5 / 0 (default) / -0.5 / -1.0 / -1.5 / -2.0
Microphone
Turn on/off the microphone during video recording.
Disable / Enable (default)
Video Length
Set the recording length of each recorded video file.
1 min / 3 mins (default) / 5 mins
Video Stamp
Display the current time of the event or GPS information of the
video being recorded.
Disable / Enable (default)
Loop
Recording
Overwrite the earliest video files with new ones if the microSD card
capacity is full.
Disable / Enable (default)
Light
Frequency
Select the appropriate frequency to avoid flashing A/C light.
50Hz (default) / 60Hz
Time-Lapse
Video
Set a preferred time interval to make time-lapse videos.
Time-lapse video mode can only be enabled manually; once
enabled, it will replace Normal Recording mode.
Note: To prevent the car battery from being completely drained,
the DrivePro will automatically power off after 48 consecutive
hours of recording in Time-Lapse Video mode.
Disable (default) / 1 shot per sec / 2 sec per shot / 4 sec per shot
Driving Assistant
Icon
Feature
Function/Option
Lane Departure
Alert the driver when the vehicle veers out of a lane. This function
is activated when the driving speed exceeds the value set ahead.
Disable (default) / >60 km/h ~ 150 km/h (40 mph~85 mph)