To Next PageTo Next Page
Need help?Do you have a question about the Transition Networks SGETF1013-110 and is the answer not in the manual?
General| Product Type | Media Converter |
|---|---|
| Model | SGETF1013-110 |
| Ethernet Ports | 1 x 10/100/1000Base-T |
| Wavelength | 850 nm |
| Max Distance | 550 m |
| Power Supply | External |
| Operating Temperature | 0°C to 50°C |
| Humidity | 5% to 95% (non-condensing) |
| Fiber Ports | 1 |
| Fiber Type | Multimode |
Configure media converter settings using a 6-position DIP switch for optimal operation.
Configure the Remote Fault Detection setting via DIP switch S1 for link monitoring.
Configure Pause settings using DIP switches S2 and S3 for network performance.
Control link pass-through behavior between ports with DIP switch S4.
Enable or disable fiber auto-negotiation for the fiber link with DIP switch S5.
Configure loop-back testing for diagnostics with DIP switch S6.
Set DIP switches for initial installation mode, disabling pass-through and auto-negotiation.
Set DIP switches to default UP position for normal operation after installation.
Connect fiber optic cables to the media converter and the remote device correctly.
Connect the RJ-45 copper cable between the media converter and the network device.
Monitor media converter status using PWR, LKF, and RXC LEDs.
Understand the function and proper usage of the Remote-Fault Detect feature.
Configure the pause feature for network performance optimization and buffer relief.
Use AutoCross feature for automatic MDI/MDI-X cable configuration.
Monitor link status and pass loss information between copper and fiber ports.
Maintain fiber link activity while passing through link loss to the copper port.
Automatically configure speed and duplex capabilities for optimal link operation.
Enable fiber interface to detect and advertise remote device capabilities.
Use loop-back testing for diagnosing fiber or copper link segments.
Note that SNMP is not supported for these converters.
Details physical characteristics and specifications for fiber optic cables.
Continued fiber optic cable specifications and parameters.
Minimum requirements for copper Category 5 cables for gigabit networks.
Access 24-hour technical support via phone for US and Canada.
Engage in live web chat with Transition Networks Technical Support.
Access live web-based training and seminars from Transition Networks.
Contact technical support staff via email for inquiries.
Find the physical address and contact details for Transition Networks.
Information regarding the CE Mark compliance of the product.
Compliance details for FCC regulations for Class A digital devices.
Compliance for Canadian radio noise limits for digital apparatus.
Warnings and notes for Class A product in domestic European environments.
Warning about potential radio interference in domestic environments.
German warning regarding potential radio interference.
French warning regarding potential radio interference.
