P12
Temperature settings for multi-temperature models
The temperature control(s) and setting(s) are adjusted from your wine cabinet’s
settings panel, as shown below.
Multi-temperature cabinet models have a temperature range starting at 6°C to 8°C
(42°Fto 46°F) at the bottom and reaching 14°C to 18°C (57°Fto 64°F) at the top.
• In the lower section, the original set temperature is 7°C, on leaving the factory.
It is possible to adjust the temperature setting. Please note, however, that there is
no upper or lower limit.
Please note: Its recommended setting range is 6°C to 8°C (42°F to 46°F).
T
o adjust the temperature of your “lower” section:
Comments: As soon as you see the display flash during setting, you have approximately 50
seconds to change or confirm, otherwise, you must restart the process.
If the setting has not been recorded, your cabinet will retain its original settings.
Press and hold down the key for 5 seconds. “St” will appear on the display.
Press , “F4” will appear on the display (“F4”: chilling compartment tempera-
ture setting).
Press You will be able to read the set temperature displayed.
Press to increase the set temperature, or
Press to lower the set temperature.
To record your setting, press the button and hold for 5 seconds, until the tem-
perature is displayed. Otherwise, it will be necessary to restart the process.
Otherwise, it will be necessary to restart the process.
Lower temperature
display
Cold circuit indicator light (Green)
Hot circuit indicator light (Red) Lighting
ON / OFF
switch
General ON / OFF
switch
Upper temperature
display
Lighting (LED1)
Lighting (LED2)
Keyboard
Pressing! for
5 seconds
allows you
to access:
“ST” allows you to set the wine
maturing temperature (for 1 and 3
temperature models) or the upper
section (for multi-temperature
models).
Pressing Set: Allows you to read
the set temperature of the “ST”
setting.
Pressing Set twice: Allows you to
return to the “ST” display
Allows you to change from “ST” to “F4” then “H4”.
“F4” Allows you to set the tempera-
ture of the chilling compartment (for
3 temperature models) or the lower
section (for multi-temperature
models)
Allows you to change from “ST” to “F4” then “H4”
Pressing Set: Allows you to read
the set temperature of the “F4”
setting.
Pressing Set twice: Allows you to
return to the “F4” display.
Pressing Set: Allows you to read
the “H4” setting value:
H4=O means that the warning
alarm is active.
H4=1 means that the warning
alarm is disabled
Pressing Set twice: Allows you to
return to the “F4” display.
“H4” Allows you to activate or disa-
ble the warning alarm, if a malfunc-
tion occurs.
« ST »
« F4 »
« H4 »
To Next Page
