P 13
GB
Temperature Settings for all models
°C / °F Conversion Table
°C °F
6 42
8 46
10 50
12 54
14 57
16 60
18 64
20 68
It may be that despite the recommendations in this manual, you still do not
achieve quite the desired temperature. Every situation is unique, and it may
be that a few slight corrections are needed.
important
You will need to wait approximately 48 hours before noticing the effects of
a temperature adjustment.
important
• In the “upper” section, its original temperature setting is 16°C (60°F), on lea-
ving the factory. It is possible to adjust the temperature setting.
It is possible to adjust the temperature setting, within a recommended range of
14°C to 18°C. (57,2 to 64,4 F°)
Please note that the lower and upper limits of this setting range are 6°C and 18°C
(42,8 to 64,4 F°) respectively.
T
o adjust the temperature of your “upper” section:
Please note:
- Once you see the display flash during setting, you have about 50 seconds to change or
confirm your setting, otherwise you will have to restart the process.
- If no setting has been recorded, your cabinet will retain its original settings.
Press and hold down the key for 5 seconds. “St” will appear on the display (“St”:
maturing temperature setting).
Press you will be able to read the set temperature displayed*.
Press to increase the set temperature, or
Press to reduce the set temperature.
To save your setting, press the button and hold for 5 seconds, until the tempe-
rature is displayed.
Otherwise, it will be necessary to restart the process.
Please note:
- The lighting function is manually controlled (“Light” On/Off switch). If you are no longer
using it, remember to switch off the lighting.
To Next Page
Loading...
