Transtherm ERMITAGE - Page 3

GB
P3
Zoom to the control display
Corresponds to target setting 1 (cold operation (compressor) for 1Ts; hot
operation (heater) for 3Ts / MultiTs)
Corresponds to target setting 2 (hot operation (heater) for 1Ts; cold ope-
ration (compressor) for 3Ts / MultiTs)
Temperature alarm indicator.
Fault indicator
-Turns off the audible alarm (audible warning signal).
- If it is pressed for more than 5 seconds, the programming menu
appears.
- It allows you to change from one parameter to another.
- It allows the parameter value to be changed.
It displays and / or allows the set point, parameter value to be program-
med.
- It allows you to change from one parameter to another.
- It allows the parameter value to be changed.
1
2
3
4
5
6
7
8