ENGLISH
31
www.trapp.com.br
Where to Turn it On
Before turning it on, always verify if the voltage
of the brush cutter matches the power supply
voltage.
With the brush cutter on the floor, bend the
extension (1) next to the female plug, leaving
enough size to connect to the engine outlet male
plug (2).
Couple the bending in the lock extension (3),
according to next figure and only then connect
the extension male plug in the power supply.
Image merely illustrative
Only for Three-Phase Version - Master 3000
Verify if the voltage of the power supply is the
same as the equipment (220 or 380 V).
Standardize the wall outlets which the machine
will use, preferably choosing those with guide-pin.
Install the male plug in the brush cutter and
make a test: turn it on and off in order to verify
the rotation direction. The correct rotation is
counterclockwise.
If the rotation direction is wrong, alter the
position between the wire phases of the machine
outlet (this work is recommended to a qualified
professional).
When the rotation is right, standardize all wall
outlets and test again.
Also standardize the extensions.
The rotation in the wrong direction may release
the blade and cause severe accidents. Refasten
the nuts that fixate the blade.
Note: This test and the standardization are
necessary only for the three-phase model.
Switch - Master 1000
With the purpose of providing maximum safety
to the operator, TRAPP implemented in the brush
cutter Master 1000 an ON/OFF switch of double
activation. It work as follows (figure 5):
To turn on the brush cutter just activate the switch
1 and the switch 2 together.
Attention!
Releasing both switches the brush cutter will
turn OFF.
Switch 1
Switch 2
Figure 5
Image merely illustrative
To Next Page
Loading...
