ENGLISH
32
www.trapp.com.br
Switch - Master 3000
Gatilho
Trava
Image merely illustrative
Trigger
Lock
Before operating the brush cutter, one must study
carefully the switch operation that in Master 3000
is of the lock trigger-type.
It works in two manners.
One of them is with the touch, keeping the finger
pressure over the trigger.
The other, when activating the trigger with the
index finger, and pushing the lock with the thumb,
is possible to release the trigger and the engine
keeps continuously working. In this condition, in
order to turn off the equipment, you just need to
activate and then release the trigger.
Voltage Selection Key - Master 3000
In the single-phase model (see figure) the side
brush cutter is equipped with a voltage selection
key 110/220 V.
Note: The selection key replacement is not
covered by warranty.
Image merely illustrative
Lubrication
Every 30 hours of use
Fill the transmission box with grease, applying
through the opening after removing the screw (1),
according to drawing.
The box is already greased from factory, when
lubricating the amount of grease can vary from 10
grams or less, according to work condition. Use
regular grease for bearing.
Attention!
In the transmission box, use grease Texaco
Marfak, graxa Litoline MP Ipiranga or Graxazul
da FAG, all found in TRAPP Authorized
Technical Assistante Network.
1
Image merely illustrative
To Next Page
Loading...
