✔ Keep safety devices in adequate places
and in usage conditions.
✔ Do not exceed an inclination of 15°
(fifteen degrees) for continuous operation.
✔ Do not tilt the product when turning the
motor on unless it has to be tilted to start.
In that case, do not tilt more than
necessary and only lift the part that is
away from the operator. Make sure both
hands are in operation position before
placing the product back on the floor.
✔ Do not turn the machine on its side or
upside down, so as to avoid oil entering
into the air filter and carburetor.
✔ Do not overuse the equipment. Use it in
the right way and for the purposes
described in this manual for better
performance and safety while working.
✔
Do not allow people that are not
familiarized with the equipment to use it.
The equipment may become dangerous
on the hands of people not familiar with
its operation.
✔ Use the equipment during daylight or
under good illumination only.
✔ Move transversely to slopes and small
elevations; never move up and down.
✔ The cutting blade keeps moving after
the equipment is switched off.
Therefore be aware of that when
servicing.
✔ Never use a water jet to clean the
equipment, as it can damage the electric
circuits of the engine. Use a damp cloth
and neutral detergent.
✔ Recommendations on use, type and
maximum length of extension cord to be
used (see “Table for the Correct Use of
the Extension Cord) (cords follow
Standard ABNT NBR NM 60335-1,
clause 25.7).
ENGLISH
53
4 - Service:
✔ According to NR12, item 12.135,
“maintenance must only be carried
out by qualified, skilled professionals
or authorized to do so”.
Use original parts only. Always call
TRAPP Authorized Service
Technicians. TRAPP is not
responsible for possible accidents
caused by the use of spare parts that
are not original.
To Next Page
Loading...
