WIRELESS PAIRING
Make sure TREBLAB Z2 is fully charged, and the AUX cable is not plugged in.
Turn ON your headset by long-pressing POWER button for 3 seconds.
You will hear the “Power on” sound clue. Do not release the button, until
you hear “Pairing” voice prompt, and the LED will start flashing BLUE,
indicating Z2 is in pairing mode.
1. Activate Bluetooth® function on your device and keep it within 3
feet / 1 meter while pairing.
2. Using your device, scan/search for available Bluetooth® devices.
3. Select TREBLAB Z2 from the device list.
4. If prompted the password, enter “0000”
5. Once Z2 is successfully paired and connected, the LED will start
flashing BLUE slowly.
After the connection is lost, the Z2 will try to reconnect automatically
to the last paired device. If reconnection does not happen
automatically, the headset will start looking for the previously paired
device within effective distance range. The headphones can
remember 8 recent devices.
TREBLAB Z2 has two operation modes, Bluetooth®
(wireless) and Line-in (connected with AUX cable)
I. BLUETOOTH MODE
To Next Page
Loading...
