K-Series Scale Operation Manual
Rev 2, 12_16_2015 11
Technical Data
The following applies to the KMR series
Power supply:
Input: The AC input requirement is 85V-265 V (50Hz to 60Hz AC (+/-15-20%);
Output: 9V DC 100mA
Allowable ambient conditions
Temperature: 0°C - 40°C, 32°F - 104°F
Relative humidity: 25% - 85%, non-condensing
If you have any questions on the technical data or require detailed technical information
on your scale, please contact your technical representative.
Getting Started
The machine is packaged in an environmentally-friendly carton, which provides
optimum protection for the machine during transportation.
We suggest that you keep the original packaging in order to avoid damage if you are
shipping or transporting the scale to a different location. It is also the best way to keep it
in the best conditions if it will not be used for an extended period of time.
In order to avoid damage, please follow the instructions provided below, when
unpacking the scale:
Unpack the scale carefully.
When outside temperatures are very low, the scale should be stored for a couple
hours and kept in its box in a dry room at normal temperature, so that no
condensation settles on the unit when opening the box.
Check the scale immediately after unpacking for any external visual damage. If
there is any damage on scale, contact customer service immediately.
If the scale is not to be used immediately after purchase, it should be stored in a
dry place where fluctuations in temperature are low. (Reference pg.).
Read through these operating instruction, before you work with the unit and pay
attention to the Safety recommendations (reference Safety pg. 6).
To Next Page
Loading...
