K-Series Scale Operation Manual
Rev 2, 12_16_2015 13
BOTTOM
Battery compartment cover
(Batteries not included)
Battery compartment
Assembly & Installation
The weighing machine is delivered in partly dismantled condition. Assemble the
individual components in the following sequence:
Place your machine on a level, clean, and dry surface to obtain accurate
readings.
Place the plastic platter on top of the scale, flat side facing up so the platter
sits firmly on the machine with the four “legs” inserted into the corresponding
four receptacles.
Place the stainless steel platter on top of the plastic platter with the flat side
facing up.
Unwrap and place the clear plastic bowl, open side facing up, on top of the
stainless platter.
Connecting AC Adapter & Installing Batteries
Remove the battery compartment cover and insert six (6) AA batteries (not included)
into the battery compartment, pay special attention to the polarities (+ / -) when
installing.
Insert the power adapter cable plug into the socket on the side of the machine
NOTE: the AC input requirement could be 110, 120, 220, 230 or 240 Volts (50/60 Hz)
depending on the area where used, so please verify that the adapter is correct.
To Next Page
Loading...
