8
Radio control states
The remote control features the following operating modes:
1
BLOCKED: this is the mode used to prevent the integrated battery from switching on and,
therefore, consuming it, during transport to the final customer. The backlight of the keys is
turned off.
2
READY: The remote control comes with backlit keys on, ready for normal use.
2a STAND BY: in the "Ready" state, it turns on if no movement was detected or by holding down
the keys for 15 second
s and not on the charging station: all functions are off.
3
NO-INIT: the remote control exited the BLOCKED mode but is not yet associated with the receiver, it
has the minus key "-" lit. This situation does not occur because the remote control comes already
associated with the receiver.
Preliminary operations
The remote control comes in "BLOCKED" mode (1) and is already associated with the receiver.
To exit Blocked mode and switch to the Ready mode, pro
ceed as follows:
_ press the hidden key for about 3 seconds, or
_ put the remote control on the charging station.
The remote control can be set to BLOCKED mode only by pressing the hidden key for at least 3 seconds.
The first start-up
Once you have activated the Ready mode (icons lit and active), the following 2 situations may occur:
a) If the RECEIVER is powered (tub plugged in), the controller will automatically indicate the presence of
the signal in a period of about 30 sec and will
displays the icons of all the functions available on the
tub.
b) If the RECEIVER is not powered (tub disconnected), the remote control will not indicate the presence of
signal and will display only 3 blinking dashes of volume in blue at the bottom of the display, which indicate
that the association signal is missing; once the receiver is powered, you will see the icons as described in
section a).
ATTENTION: if the distance from the receiver is too great, the remote control will behave in the same
way, signalling the absence of signal.
NB:
In the event of a power outage, you must place the remote control on the charging station to
react
ivate the keys.
Stand by
The remote control enters this state if:
· it fails to detect any movement or any pressure of the keys for 15 seconds;
· it is not charging.
To exit the STAND-BY mode and switch to active state, it suffices to move the remote control.
As soon as the movement is detected, the radio controller takes a few seconds to reconnect to the associated
station; during this period, you will have the same “no signal” indication (3 volum
e dashes flashing blue); once
the associated station is reconnected, the backlit of the keys resumes, showing the status of tub functions.
To Next Page
Loading...
