treesse Muse - Non-Use of the Minipool for Prolonged Periods; Closing the Minipool; Restarting the Minipool after Prolonged Inactivity

30
EN
Muse - Maya - Wave minipool
4
NON-USE OF THE MINIPOOL
FOR PROLONGED PERIODS
In case of prolonged inactivity or at the end of the summer
season it is good to carry out some simple operations
that preserve the minipool during inactivity.
CLOSING THE MINIPOOL
1
Remove the lter cartridges and dispose of them
following the current regulations in the country of
use (see page 27).
2
Completely empty the minipool (see page 28).
3
Disconnect the minipool power switch.
4
Empty the minipool by opening the drainage valve.
5
Use a soft cloth for cleaning, moistened with a
specic product for stratied resin minipools.
Do not use garden hoses for rinsing so as not to
ll the plumbing circuit with water again.
6
Dry the minipool with deerskin and protect it with
the optional cover.
OFF!
3
6
Switch: must be disconnected after the
minipool is emptied.
* The images are purely indicative: the model
and type may be different as they are chosen by
the plumber based on the characteristics of the
water and the current system.
RESTARTING THE MINIPOOL AFTER PROLONGED
INACTIVITY
• Perform a rapid cleaning of the minipool using a bit
of water and a detergent for acrylic surfaces. Do not
use cloths or cleaners that are abrasive, aggressive or
that contain solvents because they could irreparably
damage the surface of the minipool.
• Check the parameters (hardness, pH, alkalinity) of the
water that will be added. If the values are not optimal,
after lling add specic products (see page 19).
• Rell the minipool and put the new cartridges in the
lters (see page 27-29).
To preserve the surfaces it is recommended to apply wax
specic for minipools in layered resin during periods of
inactivity or at the beginning of the season. For methods
of use carefully follow the product's instructions.
Maintenance