Instructions for Use and Maintenance 120H-HY – 190H-HY (0901)
Place the snow blower on the surface which is to be cleared. Start the snow blower by slowly
releasing the oil flow while the tractor’s engine is at idle speed. Change to a higher gear.
If you want to turn off the snow blower, perform the above procedure in reverse order. 1.
Change to idle speed, 2. Stop the oil flow to the machine.
We advise you against using this equipment as a plough. Always let the equipment work its
way through the snow with the cutter turning. When clearing great masses of snow you should
work yourself through in two runs.
When operating in wet and heavy snow, more power is needed, and the equipment needs to
be used with high revs before working on the snow. If you should come to a halt, stop the
tractor, lift up the equipment, back up a bit, let the equipment down, and try again. Should
there be an obstruction in the ejector tube, the tractor and the oil flow must be stopped before
the equipment is cleaned. Inform anybody in the vicinity that work is going on with the
equipment. Drop the ejector tube and clear the obstruction.
When using the equipment for the first time in the cold season, you should set it to lean back a
little. This will ensure that the wearing edge does not pick up a lot of stones and debris that
can be ejected dangerously. After a while as the road has become hard, you can set the
equipment to a more aggressive angle.
trejonindustries.se
20
To Next Page
Loading...