Chapter 3: Adjustment 34
Training Wheels
See other sections of this manual as needed.
1. Put the bicycle on a flat, smooth surface, with
the tires correctly inflated.
2. Decrease the tightness of the rear-axle nuts.
3. Hold the bicycle up straight, and adjust the
distance between the training wheels and
the ground to approximately 1/4” (6 mm).
Make the distance the same on the two sides
of the bicycle.
4. Adjust the tension of the chain, and tighten
the axle-nuts. Use the procedures in the
Wheels section.
To Next Page
Loading...
