Trek Domanee 2017 - 4 INSTALLING THE DI2

4 INSTALLING THE DI2
TOOLS AND MATERIALS REQUIRED:
• 5 torx screws
• T8 Torx wrench
• 2 m5 bolts
• Downtube cover
1. Place the Di2 battery into the bracket.
2. Install 4 torx screws by using T8 Torx wrench.
Tighten to just snug, you do not want to strip the
plastic.
IMPORTANT
Over-tightening can
cause damage.
3. Feeding the connector in first, thread the wire into
the downtube hole.
4. Place the downtube cover over the hole. Screw the
2 m5 flathead bolts and tighten to snug.
12