TREND T5 - TECHNICAL DATA; INTENDED USE

-1-
T5
Dear Customer
Thank you for purchasing this Trend product, we
hope you enjoy many years of creative and
productive use.
Please remember to return your guarantee card
within 28 days of purchase.
CONTENTS
TECHNICAL DATA _____________________1
SAFETY ____________________________2-3
ELECTRICAL SAFETY _________________4
MANUFACTURERS DECLARATION ______5
ITEMS ENCLOSED ____________________5
DESCRIPTION OF PARTS_______________6
ASSEMBLY & ADJUSTMENT
– Dust Extractor Spout __________________7
– Handle Direction Arrow ________________7
– Switching On & Off____________________8
– Depth of Cut_________________________8
– Fitting & Removing Cutters _____________9
– Speed Control ______________________10
– Fine Height Adjuster _________________10
– Fixing Points________________________10
OPERATION
– Cutting Direction & Feed Speed ________11
– Side-fence Routing___________________12
– Template Guide Bush Routing __________13
– Beam Trammel Routing _______________14
– Bearing Guided Cutters _______________15
– Freehand Routing & Batten Routing _____16
MAINTENANCE & CARE_______________17
ENVIRONMENTAL PROTECTION________17
GUARANTEE ________________________17
SPARE PARTS
– Spare Parts List __________________18-19
– Spare Parts Diagram _________________20
TECHNICAL DATA
Voltage: UK & Eire 240V
UK & Eire only 115V
Europe 230V
Ampage: 240V 3.8A
115V 8A
Power input 850W
Power output 1400W
No load speed (min.) 240V 9,000-27,000 rpm
115V 8,500-26,000 rpm
Router carriage 2 columns
Router carriage stroke 50mm
Revolver depth stop 3-step, turret stop
adjustment with
graduation
Collet size: UK & Eire
1
/4 inch (6.35mm)
Europe 8mm
Cutter diameter, max. 40mm
Weight 2.7kg
Fuse: UK & Eire 240V 13A in plug
UK & Eire 110V 16A in mains
Europe 230V 10A in mains
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Denotes risk of electric shock.
INTENDED USE
The router is intended for routing grooves, edges,
profiles and slots as well as copy routing in wood,
wood based products and plastic. At reduced
speed with the appropriate router cutter fitted
non-ferrous alloys can also be routed.
☎
If you require further safety advice,
technical information or spare parts,
please call our technical support
department on 01923 224681 or visit
www.trendmachinery.co.uk
MANU-T5 v8.0 1/9/05 12:06 pm Page 1