7
Note:
1. To protect your network from any unauthorized access it is recommended to enable
wireless encryption.
2. The example below is for WPA2-PSK security. If you select WPA-PSK or WPA2-PSK,
make sure your wireless adapters support WPA or WPA2. If your wireless adapters
do not support WPA or WPA2, then select WEP.
5. Enter the Old password (By default, the
Password is admin), enter a New Password,
reconfirm the New Password and then click
Next.
6. Select your Time Zone and then click Next.
7. Select Wireless WAN for WAN Interface.
Select 3G or iBurst (the example shown is for
3G). Then click Next. Configure the settings
based on information provided by your ISP.
Follow the wizard instructions to complete the
configuration.
Note: Each WAN type may have different
options.
8. Enter the desired Network ID (SSID) and then
click Next.
To Next Page
Loading...
Need help?
General
