TRENDnet TI-G50 User Manual

4
3. Connect a network source and devices to the switch. Check the LEDs to
confirm the connections are established. Your installation is completed.
1. Connect the power adapter (sold separately) to the included terminal block
(as shown below) and secure the screws.
Applying Power
2. Attach the terminal block to the unit, connect the neutral wire to the ground,
and supply power to the power adapter.
Note: Polarities must match.

TRENDnet TI-G50 Specifications

General

Stackable	-
Certification	FCC CE
Rack mounting	No
Housing material	Metal
International Protection (IP) code	IP30
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	5
Full duplex	Yes
Networking standards	IEEE 802.3u, IEEE 802.3x, IEEE 802.3, IEEE 802.3ab
Copper ethernet cabling technology	1000BASE-T, 100BASE-TX, 10BASE-T
MAC address table	8000 entries
Operating temperature (T-T)	-40 - 75 °C
Power consumption (max)	2.76 W
Mean time between failures (MTBF)	510304 h
Power requirements	12 - 56 VDC / 18 - 36 VAC
Harmonized System (HS) code	85176990
Switch type	Unmanaged

Weight and Dimensions

Depth	82 mm
Width	113 mm
Height	31 mm
Weight	168 g