Why can I access my TRENDnet Security Camera locally but not remotely?
If your TRENDnet Security Camera can be accessed locally but not remotely, this could be due to a firewall. The firewall may need adjustments to allow the Network Camera to be accessible outside your local LAN. If you're using Internet Explorer, ensure it's version 6 or higher, or try viewing the video using Java.
General| Camera Technology | IP |
|---|---|
| Sensor | CMOS |
| Lens | Fixed |
| Focal Length | 3.6 mm |
| Aperture | F2.0 |
| Day/Night | Yes |
| Night Vision | Yes |
| IR Range | 30 m |
| Weatherproof Rating | IP66 |
| Frame Rate | 30 fps |
| Audio | No |
| Connectivity | Wired |
| Network Interface | 10/100 Mbps Ethernet |
| Power over Ethernet | Yes |
| Type | IP Camera |
| Image Sensor | 1/4" |
| Viewing Angle | 67° (H), 51° (V), 87° (D) |
| IR Distance | 30 m |
| Video Compression | H.264, MJPEG |
| Ethernet | 10/100 Mbps |
| Protocols | HTTP, HTTPS, TCP/IP, UDP, SMTP, FTP, DHCP, DNS, DDNS, UPnP, RTSP, RTP, RTCP, IGMP, ICMP, ARP, QoS, IPv4, Bonjour |
| Operating Temperature | -30 to 60 °C |
| Operating Humidity | 20% to 80% (non-condensing) |
| Power Consumption | 5.5W |
To Next Page
