Need help?Do you have a question about the Trianco Combi 65 ECO and is the answer not in the manual?
General| Boiler Type | Combi |
|---|---|
| Fuel Type | Oil |
| Output | 65 kW |
| Max Working Pressure | 3 bar |
| Flue Size | 125 mm |
Information for installers and service engineers regarding hazardous substances.
Details on handling insulation materials like glass rope, mineral wool, and ceramic fibre.
How to adjust temperature settings for heating and hot water.
Pre-firing checks and procedures before igniting the boiler.
Recommended type of oil and considerations for its use.
Basic troubleshooting steps for common burner starting issues.
How to report a fault or breakdown with the appliance.
Procedures to follow when the appliance experiences a fault or breakdown.
Compliance with British Standards and building regulations for installation.
Installer's responsibilities under the Health and Safety at Work Act.
Requirements for integrating the boiler into central heating and hot water systems.
Guidelines for selecting and fitting expansion vessels.
How to connect the boiler to the heating water system.
Details on the electronic programmer's features and operation.
Essential information regarding the oil supply system.
Setup for a single pipe gravity oil supply system.
Setup for a two pipe suction lift oil supply system.
Guidance on flue system design and installation for safe operation.
Benefits and considerations for balanced flue systems.
Details on the vertical balanced flue kit.
Connecting the boiler to the domestic hot water supply.
Instructions on programming the ON/OFF times for heating and hot water.
Requirements and safety considerations for the electrical supply.
Guidelines for the size, location, and installation of oil storage tanks.
Installation details for conventional chimney systems.
Essential guidance on applying lubricants and sealants to flue joints.
Detailed steps for commissioning the boiler after installation.
Procedures for servicing the boiler with the burner removed.
Troubleshooting steps specifically for burner-related faults.
To Next Page