Tribe PASS - Page 3

Trïbe Technologie – PASS Manual Page 3
We thank you for purchasing your new PASS system
Our PASS audio routing system for musicians is the result of more than 5 years of research and
development, as well as surveying musicians, to give you the facility and absolute control over
your gear. With the master unit, you will be able to control up to 24 loops and 6 channels
(IN/OUT or N.C. /N.O.).
-Master unit:
- Equipped with a memory bank of 128 presets (0-127) on each SD card, it responds
to Program Changes (PC) and Control Changes (CC) received from any external
Midi controller or from its internal controller.
- All system configurations and unit’s 128 presets are saved on the SD card. This
allows you to:
o Have more than 128 presets, by changing the SD card during the show
(Entracte), you can have a new configuration and 128 new presets for the second
part of the show.
o Back-up your settings on your computer or on another SD card.
o Easily transfer your settings from one unit to another. (Useful when you have
more than one set-up during a tour)
- It can be programmed to respond to all incoming Midi signals simultaneously on all
Midi channels (Omni) or on a specific channel (1 to 16).
- All 24 loops and 6 channels (IN/OUT or N.C. /N.O.) can be individually configured
to change their state (On/Off) with the use of the control button on the front panel or
by Control Change (CC). (see configuration section for more details).
- Each loop and Channel can be configured between latching or momentary
(Momentary is on for 0.5 seconds, then off)
- Complete programming can be done on the unit or on a computer with the use of our
editor program (For Windows) supplied with the unit.
- An LCD screen displays the number of the preset in use, the name attributed, and the
main menu when editing.
- Equipped with 24 loops and 6 channels (IN/OUT or N.C. /N.O.).
- Equipped with a passive IN and an active IN (Unity Gain Buffer).
- The unit has a complete internal cabling system with breakpoints IN and OUT. You
can connect your instrument into the back ACTIVE IN and have the signal on the
OUT 6 without the use of patch cables. You can split the daisy-chain to have 6 X 4
loops, 3 X 8 loops, 2 X 12 loops, 1 X 12 loops + 2 X 6 loops, etc… (see Internal &
back connection section and example in the appendix section for more details)