8 | P a g e
TRIDENT AIR MINI – BY PLASMA SCIENCE
locations such as bathrooms.
ABOUT MOVING
1. When moving the machine, ensure that it is unplugged.
2. To prevent the machine from falling and injuring people, grab
the handle on the side of the machine while moving; do not hold
the front panel.
NOTICE FOR CLEANING
1. Never wash the carbon filter with water.
2. Use caution when cleaning the equipment because harsh
detergents that are corrosive will scratch the surface.
3. Always use soft cloths to wipe machine surfaces; otherwise,
they risk being fractured or damaged.
4. Avoid using alcohol or other organic solvents to clean the
device because doing so could harm it or result in electric
shock, fire, etc.
5. Please unplug the machine from the electrical outlet while
cleaning or not using the machine, as doing so could result in
an electric shock or a fire from a short circuit.
CLEANING & MAINTENANCE
INLET AND TOP OUTLET GRILLE CLEANING
1. To get rid of dust and debris, use a soft brush.
2. Avoid using any abrasives or cleaning pads on any sections of
the equipment and, if necessary, use a paper or cloth that has
been mildly moistened to remove big deposits.
VOC SENSOR CLEANING
Above the air inlet grille, on the machine's middle right side, is where
you'll find the VOC sensor.
1. To preserve precise smell identification, wipe away dust and
debris from the VOC sensor using a soft cloth.
2. Avoid tampering with the opening, or spraying water near the
grille aperture above the VOC sensor as this could void the
sensor's warranty.
PM2.5 SENSOR CLEANING
1. Remove the PM2.5 Sensor cover.
2. Clean the lens, air intake, and air output with a damp cotton
swab.
3. To get rid of any remaining water stains on the dust sensor, use
a dry cotton swab.
4. Clean the PM2.5 sensor whenever readings is erratic.
To Next Page
Loading...