5.1.3. Mixed installation with DGC and MSensor
½ CAUTION!
Note the following, if you are using a mixed installation with DGCs and MSensors:
If the DGC is moved to group 1 (for example), it will still send its own presence as Broadcast by default.
If there is an MSensor in the same installation (for example in group 2), then group 2 will be triggered by the Broadcast signal sent
from the DGC.
To avoid this behaviour, make sure that the DGC is programmed to send its presence to the group that it is assigned to (in this
example group 1).
To Next Page
Loading...
Need help?
General