Response to DALI query commands at the DALI IN interface
Command
Reaction basicDIM DGC
QUERY STATUS
According to DALI
QUERY CONTROL GEAR Response is always "Yes" (0xFF), independent of what control gear is connected to CH1/CH2
QUERY LAMP FAILURE Error bit is set if at least one connected device reports an error
QUERY LAMP POWER ON Answer is "yes" if at least one output channel is on
QUERY LIMIT ERROR According to DALI
QUERY RESET STATE According to DALI
QUERY MISSING SHORT ADDRESS According to DALI
QUERY VERSION NUMBER According to DALI
QUERY CONTENT DTR According to DALI
QUERY DEVICE TYPE According to DALI
QUERY PHYSICAL MINIMUM LEVEL According to DALI
QUERY CONTENT DTR1 According to DALI
QUERY CONTENT DTR2 According to DALI
QUERY ACTUAL LEVEL is Current nominal value of output channel 1 is answered (even if output channel 1 0% and
is output channel 2 > 0% ).
QUERY MAX LEVEL According to DALI
QUERY MIN LEVEL According to DALI
QUERY FADE TIME / FADE RATE Fade Time according to DALI Fade Rate always "8".
QUERY GROUPS 0-7 According to DALI
QUERY GROUPS 8-15 According to DALI
QUERY RANDOM ADDRESS (H) According to DALI
QUERY RANDOM ADDRESS (M) According to DALI
To Next Page
Loading...
Need help?
General