Trigon HF-2 - Programming Information; General Programming Information; Autodialed Numbers; Site ID Number

Page 6
HF-2
PROGRAMMING INFORMATIONPROGRAMMING INFORMATION
PROGRAMMING INFORMATIONPROGRAMMING INFORMATION
PROGRAMMING INFORMATION
General Programming Information
The "Initial Setup" for the HF-2 has been programmed
at the factory. These factory default settings may be
changed to better suit your particular application. If you
decide to alter these settings, follow the instructions
below. It is important that each programming step be
taken in order. When reprogramming a specific feature,
you must always enter the programming mode first. You
may then go to the appropriate procedural steps for the
changes desired.
Record below the autodialed numbers to be programmed
into the HF-2.
NOTE: This symbol: ☎ resents response tones sent
from the unit while programming.
Autodialed Numbers
Primary Emergency Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
Second Emergency Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
Third Emergency Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
Fourth Emergency Number (12 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
Fifth Emergency Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
First Information Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
Second Information Number (16 digit max)
__ __ __ __ __ __ __ __ __ __ __ __
PROGRAMMINGPROGRAMMING
PROGRAMMINGPROGRAMMING
PROGRAMMING
(A) To Enter Program Mode:
1. Call the telephone number of the unit.
2. Listen for the two second tone.
3. Enter "#" then the unit's Program Code
☎☎.
4. If desired, exit Program Mode by pressing '#'
(wait for two second tone).
5. To terminate call, press '7'.
If the unit is new, use the preset factory code. (Factory
code is 9753).
(B) Setting the Information and Emergency
Telephone Numbers:
1. Unit must be in Program Mode.
2. Press '2' then '1' ☎ and enter the first
Emergency Phone Number. Press '#' when
complete
☎☎ .
Press '2' then '2'
☎ and enter the second
Emergency Phone Number. Press '#' when
complete
☎☎ . Repeat for up to five Emergency
Phone Numbers.
Press '2' then '9'
☎ and enter the first Information
Phone Number. Press '#' when complete
☎☎ .
Press '2' then '0'
☎ and enter the second
Information Phone Number. Press '#' when
complete
☎☎ .
3.To terminate call, press '7 '.
This number identifies the unit upon request from a
central office.
(C) Setting the Site ID Number:
1. Unit must be in Program Mode.
2. Press '1' .
3. Enter a four digit number
☎☎ .
4. If desired, exit Program Mode by pressing '#'
(wait for two second tone).
5. To terminate call, press '7'.
(D) Changing Program Access Number:
This will change the factory preset number of '9753'.
1. Unit must be in Program Mode.
2. Press '3'.
3. Enter a new four digit number
☎☎ .
4. If desired, exit Program Mode by pressing '#'
(wait for two second tone).
5. To terminate call, press '7'.
Site I.D. number)
__ __ __ __