CHAPTER
9
EZ-Guide 250 System Cabling Guide 77
Connecting an EZ-Remote Joystick 9
In this chapter:
Connecting an EZ-Remote joystick
to the EZ-Guide 500 lightbar
This chapter describes the cabling option to
connect the EZ-Remote joystick to the
EZ-Guide 500 lightbar.
Note – Ensure that firmware version 5.10 or
greater is loaded on the EZ-Guide 500 lightbar.
For information on configuring the EZ-Remote
joystick for use with a display refer to the
display documentation.
To Next Page
Loading...
