Trimec RT12 Series - INSTALLATION; Mounting

Installation 7
Integral meter mounting
6
3. INSTALLATION
3.1 Mounting
Panel mounting
Cut a 75mm ( 3”) dia. hole in
panel. Existing O-ring seals
against panel face
If using the cable gland supplied
carefully drill a 12.5mm (½”) hole at
bottom or rear of housing as shown
on housing footprint detail on page 7
42.6 mm
( 1.7 ” )
18 mm
( 0.7 ” )
80 mm ( 3.15 ” )
Wall - surface mount using optional bracket kit ( P/No. AWM )
Pipe mounting ( P/No. APM )
APM adaptor pipe
mount kit is suitab le
for vertical or
horizontal pipes
If using the cable gland
supplied carefully drill a
12.5mm (½”) hole at
the underside or from
the inside rear of
housing
Surface mount footprint
Use only the 4
special length
self tapping
screw s supplied
( 1.67 ” )
Cable diameter range
is 2.9~6.4mm (⅛~¼”)
42.6mm