Date: April 14, 2020 Doc No: PS-M-0871 Ver: B Page 3 of 21
Do NOT use water to extinguish fires of an electrical origin.
Do NOT install or handle modules when they are wet or during periods of high wind. At the
installation site, take care to keep modules and in particular their electrical contacts, clean and dry
before installation. If connector cables are left in damp conditions then the contacts may corrode.
Any module with corroded contacts should not be used.
Please do NOT loosen or unscrew the PV module bolts. This may lead to a reduction of the
module’s load rating and potential damage from a fall.
Do NOT drop PV modules or allow objects to fall down on the PV modules.
Do NOT touch the terminal box or the ends of the output cables (connectors) with bare hands under
sunlight, regardless of whether the PV module is connected to or disconnected from the system.
3. UNLOAD/TRANSPROTATION/STORAGE
Precautions and general safety rules:
The modules should be stored in the Trina original package before installation. Protect the
package from damage. Unpack the modules as per the recommended unpacking procedures.
The whole process of unpacking, transport and storing should be handled with care;
Do NOT stand, climb, walk or jump on unpacked pallets of modules;
Before installation, ensure that all modules and electrical contacts are clean and dry;
If the modules are required to be stored temporarily, they should be stored under dry and
ventilated conditions;
Unpacking must be carried out by two or more persons at the same time. It is forbidden to use
the wires or junction boxes of the modules to carry the modules. Handling the modules requires
two or more people with non-slip gloves; Do NOT handle the modules over-head or stack the
modules;
Do NOT put the modules in a place that is not supported or stable;
Do NOT allow the modules to come in contact with sharp-pointed objectives to prevent them
from scratches, avoiding a direct impact on the safety of modules.
3.1 MAKERS ON OUTER PACKAGING
Do NOT discard the modules at will; special
recycling is required
Modules must be kept dry, not expose to rain or
moisture
Modules in carton are fragile, which must be
handled with care
The packaging must be transported upright
To Next Page
Loading...