Date: April 14, 2020 Doc No: PS-M-0871 Ver: B Page 7 of 21
4. UNPACKING INTRODUCTION
4.1 UNPACKING SAFETY ：
For unpacking outdoors, it is prohibited to operate in rainy conditions. Because the carton will
become soft and damaged after it gets wet in the rain. The stacked PV modules (hereinafter
referred to as "modules") may tip over, which may cause damage or injury to personnel.
For a windy site, it is necessary to pay special attention to safety. Especially, it is NOT
recommended to transport the modules in high wind conditions. The unpacked modules must be
tied down to avoid any unwanted movement.
The work surface is required to be level to ensure that the package can be placed stably, avoiding
sliding.
Wear protective gloves during unpacking to avoid hand injury and fingerprints on the glass surface.
Module information and unpacking instructions can be found on the outside of each package.
Please read the instructions before unpacking.
Each module shall be handled by two persons. It is forbidden to use the wires or junction boxes
of the modules to carry the module. Do NOT take the module out of the carton by pulling on
the long side frame.
4.2 UNPACKING STEP ：
4.2.1 Before unpacking, please check the product
name, serial number and related suggestions on the
A4 paper. Please read the unpacking instructions
carefully. NO other customized unpacking method is
allowed.
4.2.2 Cut the two packing belts at shorter
sides of the tray with blade or scissors, and
unpack the side surface of the carton along
the vertical direction.
Cut the tape at shorter edge and hold it up by 90°
from the bottom; and pull out the cardboard to
expose the modules.
Cut the two horizontal packing belts in the
carton and cut the two packing belts near
the bottom of the tray, and remove the
packing belts
A4 paper (product
name, serial
number, related
suggestions, etc.)
To Next Page
Loading...